Flywheel Test Platform for Traction and Blended Braking Development
A flywheel-based development platform representing vehicle inertia for traction motor control and electric–mechanical blended braking algorithm development.

- Delivery year
- 2024
- Application
- Laboratory development of railway traction motor control, electrical braking, and electric–mechanical blended braking algorithms.
In 2024, NSAD developed a flywheel-based train-inertia simulation platform for traction motor and braking algorithm development. The rotating flywheel represents a physical inertial load under controlled laboratory conditions. Its base flywheel-mass configuration is 300 kg, adjustable up to 500 kg. The platform operates with a 0–300 VDC DC link and a 2 kW motor configuration, expandable up to 5.5 kW.
NSAD MRCU-6U and MRCU-9U controllers coordinate the three-phase inverter, an IGBT braking chopper with braking resistor, and the mechanical drum brake. For mechanical braking, a 4–20 mA signal commands the electro-pneumatic regulator, while a 24 VDC solenoid valve controls the pneumatic supply to an air-to-hydraulic actuator. The drum brake is hydraulically applied and spring released. Feedback includes air pressure, motor speed/position, electrical voltage and current, and temperature measurements.
By combining electric drive control with pneumatic-hydraulic brake actuation, the platform supports development of traction, electrical braking, and electric-mechanical blended-braking algorithms. It demonstrates NSAD’s ability to integrate embedded controllers, power semiconductor switching, electrical machines, mechanical inertia, pneumatics, and hydraulics into one motion-control development system.
Technical Highlights
- DC-link voltage range
- 0–300 VDC
- Motor power configuration
- 2 kW, expandable up to 5.5 kW
- Configurable flywheel mass
- 300 kg base, up to 500 kg
- Integrated controller
- NSAD MRCU-6U & NSAD MRCU-9U
- PWM Control
- Up to 10 kHz
- Electrical braking
- IGBT chopper and braking resistor
- Mechanical braking
- Pneumatic-hydraulic drum brake
- Pneumatic pressure command
- 4–20 mA
- Brake solenoid command
- 24 VDC
- Measurement feedback
- Speed, voltage, current, temperature and air pressure



